Filter
Top Products
Model H6082, H6083, and H6086 Heirloom Electric Guitar Kits -15-
Audio Jack
Components Needed Qty
Guitar ................................................................. 1
Jack Plate .......................................................... 1
Washer 9MM Gold ............................................
1
Nut 9MM Gold ...................................................
1
Tap Screw M3 x 12 ........................................... 4
Tools Needed
Socket 11MM ......................................................
1
Drill with a
1
⁄16" Drill Bit ....................................... 1
Depth stop .........................................................
1
Phillips Head Screwdriver ..................................
1
To attach the audio jack to the guitar body:
1. Insert the audio jack into the hole in the jack
plate, place the washer over the threads, and
secure with the nut (see
Figure 21).
Figure 21. Jack plate.
2. Place the jack plate in the hole in the guitar.
3. Secure the position of the jack plate to the
guitar body with masking tape.
4. Use
1
⁄16" drill bit to drill
1
⁄2" holes through the
holes in the jack plate and into the body.
5. Secure the jack plate to the guitar body with
four tap screws.
Strap Buttons
The strap buttons are positioned on the guitar as
shown in
Figure 22.
Components Needed Qty
Guitar ................................................................. 1
Tap Screw
s ....................................................... 2
Strap Buttons .....................................................
2
Tools Needed
Drill with a
1
⁄8" Drill Bit .........................................1
Phillips Head Screwdriver ...................................
1
To attach the strap buttons to the guitar:
1. Using an
1
⁄8" drill bit, drill
3
⁄4" deep holes at
each of the mounting locations
.
2. Secure each of the strap buttons to the guitar
body with a tap screw
.
Figure 22. Strap buttons.