Filter
Top Products
Setting up
36 DMS 70
DMS 70DMS 70
DMS 70 Quattro/Dual
Connecting an instrument
1) Remove the battery compartment cover (22).
2) Plug the jack plug on the MKG L guitar cable into the output jack of your instrument and
the mini XLR connector on the guitar cable into the audio input socket (19) of the
bodypack transmitter.
3) Slide the slide cover (20) to the rear position and switch on the bodypack transmitter
using the on/off switch (15).
4) Assign a free channel to the bodypack transmitter and receiver.
5) Play your instrument.
6) Use the screwdriver integrated in the battery compartment cover to set the GAIN control
(23) to a position where the CLIP LED (6) on the receiver will flash occasionally.
7) Replace the battery compartment cover on the transmitter.
Use the VOLUME potentiometer (2) to adjust the audio output level on this channel (10/10a).
Connect the DSR 70 Quattro receiver to an active speaker and use the VOLUME
potentiometers of the active channels to adjust the sum output (9) based on the Mixing
Function.
In an undisturbed environment, set the AUTO CORRECTION switch (8) on the back of the
receiver to "Low" which guarantees an optimum transfer time.
If another interfering device in the 2.4 GHz ISM frequency range causes unwanted signals
near the receiver, this can cause interference. Increase the internal error correction by
adjusting the AUTO CORRECTION switch to the "Mid" or "High" setting.
It is sufficient to switch off the receiver to switch off the DMS 70 system. The receiver
switches off all transmitters connected to it.
Adjusting the audio level on the receiver
Adjusting internal error correction
Switching off DMS 70 System