Filter
Top Products
Page
30
FUNCTION MODE
5
10) TRANSMIT MIDI PROGRAM CHANGE
This function determines whether or not the CN21 piano will transmit program change information when sound
types are changes. It is also possible to transmit a program change number (ranging from 1 to 128) in order to
change the sound type of an external MIDI sound source.
Step 1
Press and hold the METRONOME and SOUND SELECT buttons at the same time, then press the key
assigned to the PROGRAM function.
Step 2
While still holding down the METRONOME and SOUND SELECT buttons, press the '-(off)' key to disable
transmitting program change data when selecting sounds, or the '+ (on)' key to enable transmitting
program change data when selecting sounds.
The TRANSMIT PROGRAM CHANGE setting is set to 'off' when the CN21 piano is turned on.
Step 3
To transmit the desired program change number directly, fi rst press and hold the METRONOME and
SOUND SELECT buttons at the same time, press the key assigned to the PROGRAM function, then
enter the three digit number using the lowest 15 number keys.
Three digit program change numbers ranging from 001 to 128 can be transmitted. For example, press '0', '0', and '1'
to transmit program change number 1.
The program change number will be transmitted as soon as the key for the third digit number is pressed.
0987654321
+-
onoff
number keys
Transmisson On
Transmisson Off
Use these keys to specify the program change number to be transmitted.