Filter
Top Products
Page
35
6
APPENDICES
3. Place the piano on the front half of the stand so that the metal
fi tting holes are seen when viewed from the top. Slide the
piano backward while holding it with one hand so that it does
not incline and fall from the stand. The hooks on the piano are
then engaged with the metal fi ttings on the Side Panels. Pay
attention so that hands or fi ngers are not caught between the
stand and piano.
Fasten the piano and the stand with four bolts (with plain
washers and spring washers)(G).
First, loosely tighten the bolts to adjust the unit position in
order to make sure that all four bolts can be inserted straight.
Then, tighten the bolts.
Make sure that the bolts are tightened until the spring washers
collapse.
4. Insert the pedal connection cord that comes from Pedal Board
(C) into the piano’s pedal jack and fasten with cord clamps.
5. Fix the headphone hook to the location marked with red ink by
using two tapping screws provided in the same plastic bag.
6. Turn the Adjuster (installed on the bottom of C) until it touches
the fl oor to support the pedal board.
Caution
y
Ensure that the CN22 digital piano is correctly secured to the stand by using the bolts included.
Failing to do so may result in the unit falling from the stand, causing damage or personal injury.
Caution
y The pedal board may break if the adjuster
is not touching the fl oor correctly. When
moving the CN22 digital piano, ensure that
the unit is lifted clearly from the fl oor and
not dragged.
Hand or Finger
catching hazard
(G)
backside of the unit
Pedal jack
Cord
clamp
Pedal
cord
connector
Locking
tab
Red mark
Adjuster
Pedal board
Floor