Filter
Top Products
25
Assembling the ST-4500
Caution
Use two or more people to assemble the stand.
When placing the piano on the stand, be careful not to
pinch your hand.
Be sure that the correct parts are assembled in the
correct orientation, and follow the steps in the order
that they are given.
If you apply weight to the front edge of the piano
before tightening the screws, the piano may fall down.
1. Open the packing carton and remove the
contents.
Check that all of the following items are present.
• Rear Panel 4
• Side Panel
(Left) 1
• Pedal Box 3
• Side Panel
(Right) 2
• Long screws
5
✕4
(M6 x 16)
• Adjustable bolts
8
✕2
• Adjuster
6
• Short screws
7
✕10
(M3.5 x 16)
• Cable holder
9
• In the plastic bag
2. Attach the side panel (left) 1 and side panel
(right) 2 to the pedal box 3, and use four long
screws 5 to fasten them.
3
1
5
2
• Pull out the Pedal Cord.
• Screw the Adjuster 6 into the Pedal
Box 3 until it is all the way in.
3. Attach the back panel 4.
Use four short screws 7 to fasten the bottom edge
of the back panel 4, and four screws 8 to fasten
the sides. Use one short screw 7 to fasten the
cable holder to the back panel.
4
7
• Fasten the cable holder 9 together with the back panel.
• Finished surface toward the front.
❍ At this time, make sure that there are no gaps in
the stand, and that it does not tilt.
4. Attach the piano.
Place the piano on the stand so that the plastic feet
on the bottom of the piano fit into the holes in the
side panel brackets. From below, use four adjust-
able bolts 0 to fasten the piano to the stand.
8
8
Rotate the adjuster so that it firmly contacts
the floor. If the adjuster is not in firm
contact with the floor, the pedal may wobble
and cause malfunctions.