26 ProFX16 and ProFX22
XLR Connectors
Mackiemixersuse3-pinfemaleXLRconnectorson
all microphone inputs, with pin 1 wired to the grounded
(earthed) shield, pin 2 wired to the high (hot or positive
polarity) side of the audio signal and pin 3 wired to the
low (cold or negative polarity) side of the signal. See
Figure A.
Use a male XLR-type connector, usually found on the
nether end of what is called a “mic cable,” to connect to
a female XLR jack.
1
⁄4" TRS Phone Plugs and Jacks
TRS stands for Tip-Ring-Sleeve, the three connections
availableonastereo1/4"orbalancedphonejackor
plug. See Figure B.
TRS jacks and plugs are used in several different
applications:
• Balancedmonocircuits.Whenwiredasa
balancedconnector,a1⁄4"TRSjackorplug
is connected tip to signal high (hot), ring to
signal low (cold), and sleeve to ground (earth).
• Stereoheadphones,andrarely,stereo
microphones and stereo line connections.
Whenwiredforstereo,a1⁄4"TRSjackorplugis
connected tip to left, ring to right and sleeve to
ground(earth).Mackiemixersdonotdirectly
accept 1-plug-type stereo micro phones. They
must be separated into a left cord and a right
cord, which are plugged into two mic preamps.
Appendix B: Connections
• Unbalancedsend/returncircuits.Whenwired
assend/return“Y”connector,a1⁄4"TRSjack
or plug is connected tip to signal send (output
from mixer), ring to signal return (input back
into mixer), and sleeve to ground (earth).
1
⁄4" TS Phone Plugs and Jacks
TS stands for Tip-Sleeve, the two connections
availableonamono1⁄4"phonejackorplug.See
Figure C.
TS jacks and plugs are used in many different
applications, always unbalanced. The tip is connected to
the audio signal and the sleeve to ground (earth). Some
examples:
• Unbalancedmicrophones
• Electricguitarsandelectronicinstruments
• Unbalancedline-levelconnections
• Speakerconnections
Don’t use guitar cords for speaker cables!
They’re not designed to handle speaker-level
signals and could overheat.
RCA Plugs and Jacks
RCA-type plugs (also known as phono plugs) and
jacks are often used in home stereo and video
equipment and in many other applications (Figure D).
Theyareunbalancedandelectricallyidenticaltoa1⁄4"
TS phone plug or jack. See Figure C. Connect the signal
to the center post and the ground (earth) or shield to
the surrounding “basket.”
2
2
3
1
1
SHIELD
COLD
HOT
SHIELD
COLD
HOT
3
SHIELD
COLD
HOT
3
2
1
Figure A: XLR Connectors
SLEEVE
TIP
TIPSLEEVE
TIP
SLEEVE
SLEEVE
TIPSLEEVE
TIP
RING
RING
TIP
SLEEVERING
Figure B: TRS Plug
Figure E: Does not appear in this owner's manual, due
to a contractual obligation, but performs nightly at the
downtown Woodinville Cocoa Rooms and Tea Bar
SLEEVE
TIP
TIPSLEEVE
TIP
SLEEVE
SLEEVE
TIPSLEEVE
TIP
RING
RING
TIP
SLEEVERING
Figure C: TS Plug
TIPSLEEVETIPSLEEVE
Figure D: RCA Plug