Filter
Top Products
PAGE 24 —MIX N' GO MIXER — PARTS & OPERATION MANUAL — REV. #1 (09/09/02)
MIX N' GO MIXER — INITIAL START-UP (GASOLINE ENGINE)
7. If the engine has started, slowly return the choke lever
(Figure 23 ) to the
CLOSED
position. If the engine has not
started repeat steps 1 through 6.
8. Before the mixer is placed into operation, run the engine for
several minutes. Check for fuel leaks, and noises that would
associate with a lose V-belt cover or component.
9.
To begin mixing, place the throttle lever (Figure 26) in the
"
RUN
" position
Figure 26. Throttle Lever (Run Position)
6. Grasp the starter grip (Figure 25) and slowly pull it out. The
resistance becomes the hardest at a certain position, corre-
sponding to the compression point. Pull the starter grip briskly
and smoothly for starting.
Figure 25. Starter Grip
Figure 27. Throttle Lever (Idle Position)
2. After the engine
cools
, turn the engine ON/OFF switch to the
“OFF” position (Figure 28 ).
Figure 28. Engine ON/OFF Switch (OFF Position)
3. Close the
fuel shut- off valve
(Figure 29) by moving the fuel
valve lever to the OFF position.
Figure 29. Fuel Valve Lever (OFF Position)
Stopping The Engine
Normal Shutdown
1. Move the throttle lever to the IDLE position (Figure 27) and
run the engine for three minutes at low speed.
Emergency Showdown
1. Move the throttle lever quickly to the
IDLE
position, and turn
the engine ON/OFF switch to the
OFF
position.