Filter
Top Products
MIX N' GO MIXER — PARTS & OPERATION MANUAL — REV. #1 (09/09/02) — PAGE 25
MIX N' GO MIXER — MAINTENANCE
Maintenance
Gearbox Oil Check
1. Position the mixer on a level surface and place a
support
block
under the front of the mixer frame as shown in Figure 30. This
will level the mixer.
2.
NEVER!
check the gearbox oil level with the mixer tilted up or
down.
ALWAYS
check the gearbox oil level with the mixer in a
level position.
Figure 30. Mixer Positioning (Gearbox Oil Level)
5. Insert oil filler plug and tighten.
Figure 31. Gearbox Oil Level Check
Gerarbox Removal
1. Remove drum by turning counter-clockwise to release from
gearbox shaft.
2. Remove pulley, remember the nut securing the pulley is left-
hand threaded. Remove circlip, and draw out shaft.
3. Remove the 5 bolts securing rear plate.
4. Reassemble in reverse order, taking care to ensure gear teeth
are meshed correctly.
V-Belt Check
1. To adjust V-belts, remove V-belt cover and loosen the main
motor mount bolts, raise electric motor and retighten bolts.
Belt tension should be adjusted so that the maximum deflec-
tion is approximately 3/8 inch (10 mm).
2. Replace V-belt cover.
CAUTION :
Check the gearbox oil level
monthly
before operating mixer. Low oil level or no
oil will severely damage gearbox.
3. Before inspecting the gearbox oil level, make sure the gearbox
is cold before removing the filler plug. Hot! oil can burn skin and
cause injury. Let oil
cool
before checking.
4. Remove gearbox oil filler plug (Figure 31) and fill with EP90 or
similar gear oil to the level of the filler plug. Replace gearbox oil
every 3,000 hours. Gerabox oil capacity is
8-10 ounces
.