Filter
Top Products
PAGE 10 — WHITEMAN WM-700S, 700P — PARTS & OPERATION MANUAL — REV. #7 (06/21/01)
WM-700S, 700P — OPERATIONS
BALL HITCH COUPLER
1. Check vehicle hitch, ball, and coupler for signs of wear or
damage. Replace any parts that are worn or damaged
before towing.
2. Use only the 2" ball diameter as indicated on your coupler.
Use of any other ball diameter will create an extremely
dangerous condition which can result in separation of the
coupler and ball or ball failure.
3. Be sure the coupler is secured to the hitch ball and the
lock lever is down tight and locked.
Recheck tightness again after towing about 50 miles.
4. Check that trailer safety chains are properly connected.
DANGER If housing is deformed,
replace complete coupler.
USE ONLY GENUINE
FULTON REPAIR KITS.
DANGER BEFORE TOWING
RECOMMENDED MAINTENANCE
1. Smear ball socket and clamp face with chassis grease.
Periodically oil pivot points and solutions surfaces of
coupler with SAE 30 wt. motor oil.
2. When parking or storing your trailer. Keep the coupler off
the ground so dirt will not build up in the ball socket.
CLEANING — BLADE ADJUSTMENTS
Always disconnect the spark plug wire before cleaning the inside
of the drum.
Never pour or spray water over the gasoline engine or electric
motor.
For consistent performance, long life and high quality mixing,
thoroughly clean the mixer inside and out at the end of each
day’s operation. To prevent lumps of dried mortar from forming
and contamination of future batches, do not allow a buildup of
materials to form on the blades or anywhere inside the drum.
2) POLYETHYLENE DRUM MIXERS
The poly blade should come as close as possible to the surface
without touching. If material builds up on the drum, you may use
a rubber mallet to dislodge the material without adverse effect to
the drum.
IMPORTANT NOTICE
EPOXY COMPATIBILITY — There are some expoxies and other
chemicals used in certain applications that are not compatible
with polyethylene tubs.
Since Whiteman Industries cannot control the end user’s
application of this product, we will not assume responsibility for
the resulting damages when exposed to incompatible chemicals.
The following is the recommended wiper blade adjustments:
1) STEEL DRUM MIXERS