Nady Systems 401XQLTOSYSAB Microphone User Manual


  Open as PDF
of 12
 
4
a. Instrument Connection (using the WGT instrument transmitter)
Insertanaudiocordwitha¼”monophonepluginthe
AF OUTPUT JACK (8) on the rear panel of
thereceiver.Plugtheotherendofthecordintoamplier,effectormixingboard.Adjustthe
VOLUME CONTROL (6) on the 401X QUAD clockwise to about ¾ rotation until the volume level is
comfortableforyourapplication.Thissettingisroughlyequivalenttodirectinstrumentcord
connection. Turning the volume up to maximum will provide 4dB gain over a cord.
b. Microphone Connection (using the WLT transmitter with either a headset
or lavalier microphone or the WHT handheld microphone transmitter)
Insertanaudiocordwitha¼”monophonepluginthe
AF OUTPUT JACK (8) on the rear panel of
thereceiver.Plugtheotherendofthecordintoamplier,effectormixingboard.Adjustthe
VOLUME CONTROL (6)onthe401XQUADclockwisetoabout½MAXandadjustthevolume
control until the volume level is optimal. If the volume control is set too high, you may overload
your mixer or amp.
Since your 401X QUAD is comprised of four separate and independent XLR output channels, it
can be used with either one, two, three or four channels operating. Simply turn your mixer volume
controlofanychannelwhichyouarenotusingtominimum.Ifthemixlineoutisused,justturn
down the 401X QUAD receiver’s volume controls.
16V AC/DC Adapter Antennas
5
8 9 10 11
3 64 7
opeRaTIon
 previous next