Filter
Top Products
ng
on
12
INSTALLATION
Speaker Wire Connections
CAUTION! All speaker wire connections must be made with the amplifier Off.
Bare Wire
Unscrew the red or
black plastic knob,
insert the bare wire
end into the opening,
and then tighten the
knob until the wire is
securely clamped.
Banana Plugs
There are many types of
banana plugs, some
crimp, some solder. The
Niles gold banana plug
has a quick-connect
binding post for the
bare wire on the body
of the plug. A banana
plug is simply inserted
into the jack at the
end of the amplifier’s
binding post. Dual
banana plugs will fit the
SI-2125 binding posts.
STEP
1. Label all wires.
2. Connect one stripped wire end or
banana plug to the black terminal
and one to the red terminal.
CAUTION- Avoid even a single strand
of wire touching the chassis or another
connector.
DESCRIPTION
If you label the wires for their destination,
rather than which terminal of the SI-2125
they are connected to, it will be easier to
reconfigure your system in the future.
A. Split the speaker wire insulation so that
at least two inches of each conductor are
separated.
B. Strip one half inch of insulation from the
end of each conductor of the speaker wire
C. Attach banana plugs or twist the strands of
wire together and insert them into the
appropriate binding post.
DS00354AMY/SI-2125 10/10/03 11:12 AM Page 13