Filter
Top Products
DM1190
REAR PANEL: INPUTS AND OUTPUTS
(Please refer to diagram on page 7)
1. AC Cord. See safety precautions on page 3 for
proper treatment of the power cord.
2. GND is the grounding lug for turntables 1, 2 and 3
(phono inputs on Channels 1, 2 and 3). Always use this
connection (your turntable cable should have a
grounding wire).
3. The Stereo Main Outputs are low-impedance
RCA connectors controlled by the Master fader.
4. The Stereo Zone Outputs are low-impedance
unbalanced RCA jacks controlled by the Zone Level
control.
5. The Tape Outputs are low-impedance
unbalanced RCA jacks which output the program mix
and allow you to connect any recording device.
6. Mic 2 is the mic input for Channel 4.
7. Channels 1-5 Line Inputs are unbalanced RCA
jacks. The Line Input is selected with the toggle
switch on the front panel.
You can connect stereo audio from HiFi VCRs, cassette
and reel-to-reel tape decks, DAT machines, CD players,
laser discs, tuners, even synthesizers or other mixing
consoles.
NOTE: Plug mono audio sources into both Left and
Right inputs using a “Y” cable connector.
8. Line/Phono Input switch. Use this to allow line
level equipment to be plugged into your phono inputs
giving you a total of 8 line input options.
9. Phono Inputs on Channels 1, 2 and 3 use
unbalanced RCA jacks. Your input signal is fed directly
to the DM1190's high-quality RIAA phono pre-
amplifiers so use this position only for moving magnet
cartridges. Line level sources will overload the sensitive
phono pre-amps and will sound very bad, so always be
sure to toggle the line/phono switch over to line before
connection of line sources.
Numark - The Proven Leader in DJ Technology
©1997 Numark Industries 11
http://www.numark.com