Filter
Top Products
DM 1190
GUIDED TOUR OF FEATURES AND OPERATING
INSTRUCTIONS...
If the DM1190 is your first mixer, please read this
entire manual before you begin operation.
If you are an experienced DJ simply replace your old
mixer. The DM1190 can be rack-mounted or used
as a free-standing unit (five 19" rack unit spaces).
INSTALLATION AND OPERATION
Study the Connections Diagram on page 13.
First, connect all stereo input sources. Next connect
your microphone(s) and monitor headphones. Make
sure all faders are at "zero" and the unit is off. Finally,
connect the stereo outputs to the power amplifier(s)
and/or audio sources. Plug the DM1190 into AC
power. Now you are ready to switch it on.
The DM1190 is divided into five functional blocks:
Input, Crossfader, DJ Mic, Master/Zone Output, and
Equalizer. It is important to learn how each of these
work.
CHANNEL INPUTS/CONTROLS SECTION
1. Channels 1, 2, 3 & 4 Input Toggle
Switches select which source will be live to that
channel based on what you have connected to the
rear panel input section.
2. The Input Faders are low-noise, low-
impedance, high-quality, smooth Alps™ faders.
These control individual source levels in the mix.
3. Channel Cue Assign. The Cue pushbuttons
are used to route channel audio to the Monitor
Section. The channel faders do not control the
Cue send volume.
CROSSFADER SECTION
4. The Crossfader Assign knob to the left of the
crossfader lets you choose which input channel will
be heard when the crossfader is in the far left
position.
5. The Replaceable Crossfader achieves clean
segues between the two selected input channels.
Off1 2 3 4
Off1 2 3 4
"Hard left" selects the channel set up of the Assign
Left knob. In this example it is Channel 1. "Hard
right" selects the channel set up on the Assign
Right knob. In this example it is Channel 4. With the
crossfader centered both assigned channels are
live. Use the crossfader for fast and seamless
segues from one selected channel to the other. To
turn off the crossfader simply turn both knobs all the
way to the left.
Note: The crossfader is user replaceable in case of
failure. Simply unscrew the two large screws which
hold it in place, lift it out and disconnect it’s cable.
Re-attach the new crossfader and screw the
mounting plate back onto the unit - you’re back in
business!
6. The Crossfader Assign knob to the right of
the crossfader lets you choose which input channel
will be heard when the crossfader is in the far right
position.
Numark - The Proven Leader in DJ Technology
©1997 Numark Industries 8
http://www.numark.com