Filter
Top Products
DM1295
- The Leader in DJ Technology
©2000 Industries - 7 - http://www.numark.com
SAMPLER OPERATION
1
2
3 4 5
6
This sampler was designed for ease of use and understanding. It can retain in memory up to 110 seconds worth
of sampling. Each bank can save 27.5 seconds for playback even after the unit is shut down. It’s as simple as
(1) pressing a channel send (2) recording the sample (3) playing it back. Enjoy a whole new way to sample.
1. Output Gain Control – adjusts the volume of the sampler.
2. Pitch Adjust – changes the playback pitch of the sample. Moving left slows down the playback, moving right speeds it up.
3. Record/Play mode select – sets the operation of the sampler.
4. Stutter – is used to allow samples to play fully through until retriggering.
5. Cue – is used for monitoring the sampler.
6. Sampler Banks – for storing 4 samples up to 27.5 seconds in length.
RECORDING SAMPLES
1. Determine your audio source and press the send button of the channel you wish to sample.
2. Set the mode select to record by depressing the button once.
3. Move toggle in either direction to record the sample then move it back to the center to end the sample. The unit will
return to play mode. Using the up position allows you to sample without holding the toggle.
PLAYING SAMPLES
1. Move toggle in the down direction to play only once. If the unit is in stutter mode the sample will play to the end unless
the toggle is moved again. If the unit is not in stutter mode then playback will end when the toggle is released.
2. Move the toggle upward to play a sample as a loop. Moving multiple samples up will allow them to play in sequence.
3. While a sample is playing as a loop other samples can be played back as well as single play. One single play sample and
one loop can be played at the same time creating some very interesting effects.