Filter
Top Products
DM1295
- The Leader in DJ Technology
©2000 Industries - 8 - http://www.numark.com
REAR PANEL FEATURES
1. Power Connector. Plug in power cord here and check the
voltage level to match your country’s standard.
2. GND is the grounding lug for turntables 1, 2 and 3 (phono
inputs on Channels 1, 2 and 3). Always use this
connection (your turntable cable should have a grounding
wire).
3. The Stereo Main Outputs are low-impedance RCA
connectors controlled by the Master fader.
4. The Stereo Zone Outputs are low-impedance unbalanced
RCA jacks controlled by the Zone Level control.
5. The Tape Outputs are low-impedance unbalanced RCA
jacks which output the program mix and allow you to
connect any recording device.
6. The Send can be attached to an external effects processor
such as a sampler.
7. Line Inputs 1-5 are unbalanced RCA jacks. The Line
Input is selected with the toggle switch on the front panel.
You can connect stereo audio from HiFi VCRs, cassette
and reel-to-reel tape decks, DAT machines, CD players,
laser discs, tuners, even synthesizers or other mixing
consoles.
NOTE: Plug mono audio sources into both Left and Right
inputs using a “Y” cable connector.
8. Line/Phono Input switch. Use this to allow line level
equipment to be plugged into your phono inputs giving
you a total of 8 line input options.
9. Phono Inputs on Channels 1, 2 and 3 use unbalanced
RCA jacks. Your input signal is fed directly to the
DM1200's high-quality RIAA phono pre-amplifiers so use
this position only for moving magnet cartridges. Line
level sources will overload the sensitive phono pre-amps
and will sound very bad, so always be sure to toggle the
line/phono switch over to line before connection of line
sources.
10. The Balanced Main Outputs are low-impedance XLR
type connectors controlled by the Master fader.
11. Mic 2 is the mic input for Channel 4.