Numark Industries DM2000X DJ Equipment User Manual


 
DM2000X
CROSSFADER SECTION
7. The Replaceable Crossfader achieves clean
segues between the two selected input channels.
"Hard left" selects Channel 2. "Hard right" selects the
Channel 3. With the crossfader centered both channels
are live. Use the crossfader for fast and seamless
segues from one selected channel to the other.
Note: The crossfader is user replaceable in
case of failure. Simply unscrew the two large
screws which hold it in place, lift it out and
disconnect it’s cable. Re-attach the new
crossfader and screw the mounting plate back
onto the unit - you’re back in business!
8. The Crossfader Control toggle allows the DJ
either reverse the direction of the crossfader or turn it
off. By reversing direction Channel 3 will be on the left
and Channel 2 will be on the right.
9. Transform Buttons are for quickly reversing the
crossfader direction in order to create various special
effects.
10. Beat indicator lights show peaks in the music
that usually represent a strong drum beat. You can use
these to help you try and match up beat mixes.
MASTER/BOOTH OUTPUT SECTION
11. The Stereo Master Fader controls the overall
output level.
12. The Booth Level controls speaker volume for a
remote zone or booth monitors. If you do not use booth
monitors the output can feed a tape deck, another
amplifier, another mixer or a satellite speaker system.
Note: This can also be used to supply line level audio
to a lighting controller or to lights that are sound
activated.
CONTRACTOR'S NOTE: Booth Level provides
zone control in installations where there are two
separate rooms, or a bar and dance floor, for example.
Remote zone volume should be controlled from the
DM2000X.
13. Stereo Output Level Indicator. This fast,
accurate stereo meter tracks the output level. It's OK to
be occasionally "in the red" as long as +5dB or +8dB
aren't constantly lit. Set the crossover, equalizer and
power amp inputs to avoid distortion at each step in the
audio chain. Proper attention to the meter results in the
punchiest possible sound without audible distortion.
This meter is also used to monitor the PFL/CUE section.
When a PFL LED is lit the display indicates this
channel, when the MASTER LED is lit then the
Master output is shown.
CUE SECTION
14. The CUE section includes the Program Mix
(PGM) control, the Headphone Volume control
and the Headphone Connector located on the
front of the unit. Connect headphones with a standard
1/4" stereo plug. The PFL audio is sent to the
headphone amp using the PFL Assign
Pushbutton and the PGM Mix control. The
Program Mix controls the amount of program audio in
the headphones so that beats can be matched exactly
and segues are smooth when a song is cued.
MIC SECTION
15. The MIC Connector is located on the front panel
of the unit and is controlled through an input on
Channel 1.
16. 12V BNC Connector allows a 12 volt gooseneck
lamp to be connected directly to the mixer. This light is
readily available from your Numark dealer.
17. Power Switch and Power-On LED.
Numark - The Proven Leader in DJ Technology
©1997 Numark Industries 7 http://www.numark.com