Filter
Top Products
DM1820X
DM1820X REAR PANEL DIAGRAM...
1
2 34 5
6
7
8
9
10
12
777 7 99
8
11
1. The Balanced Main Outputs are low-impedance
XLR type connectors controlled by the Master fader.
2. The Stereo Main Outputs are low-impedance RCA
connectors controlled by the Master fader.
3. The Tape Outputs are low-impedance unbalanced
RCA jacks which output the program mix and allow you to
connect any recording device.
4. The Stereo Zone Outputs are low-impedance
unbalanced RCA jacks controlled by the Zone Level
controls.
5. The Send can be attached to an external effects
processor such as a sampler.
6. Mic is the mic input for the Mic Channel and Channel 4.
7. Channels 1-5 Line Inputs are unbalanced RCA
jacks. The Line Input is selected with the toggle switch
on the front panel. You can connect stereo audio from HiFi
VCRs, cassette and reel-to-reel tape decks, DAT
machines, CD players, laser discs, tuners, even
synthesizers or other mixing consoles.
NOTE: Plug mono audio sources into both Left and
Right inputs using a “Y” cable connector.
8. Line/Phono Input switch. Use this to allow line
level equipment to be plugged into your phono inputs
giving you a total of 8 line input options.
9. Phono Inputs on Channels 1, 2 and 3 use
unbalanced RCA jacks. Your input signal is fed directly to
the DM1820X's high-quality RIAA phono preamplifiers so
use this position only for moving magnet cartridges. Line
level sources will overload the sensitive phono preamps
and will sound very bad, so always be sure to toggle the
line/phono switch over to line before connection of line
sources.
10. AC Cord. See safety precautions on page 3 for
proper treatment of the power cord.
11. Voltage Selector. Set this for the appropriate
voltage in your area
12. GND is the grounding lug for turntables 1, 2 and 3
(phono inputs on Channels 1, 2 and 3). Always use this
connection (your turntable cable should have a grounding
wire).
Numark - The Proven Leader in DJ Technology
©1997 Numark Industries 11 http://www.numark.com