Filter
Top Products
DM 1820X
DM1820X FRONT PANEL DIAGRAM...
1
2
3 4
5 6
7
8
9
10
11 12
13
14
15
16 17
18
19
20
2122
23
1. Channel Input Gain/Trim/Attenuation Controls.
These control the sensitivity of the inputs for Channels 1-4.
Use these whenever a particular source causes overload of
the preamp inputs. Attenuation range is 0dB to -20dB. Use
these with the PFL (pre-fader listen) monitor when cueing.
2. Treble, Middle and Bass Controls fine tune the tone
of your music through the sound system. Note that these
are also available on the DJ Mic.
3. Use the Pan Control to maximize the Left or Right side of
your Source.
4. Send button will send the individual channel signal to the
send jack on the rear panel. This is used to route to an
external effects unit. The signal comes back in from the
effects unit through any line input channel you select and is
then sent out to your amplifier through the Master Output
jacks on the rear panel.
5. DJ Mic Talkover Switch. When engaged this mutes
your music sources from channels 1-4. Releasing it brings
you immediately back to full source level. It is very useful
for announcements.
6. Channels 1 - 4 Input Toggle Switches select which
source will be live to that channel based on what you have
connected to the rear panel input section.
7. The Input Faders are low-noise, low-impedance, high-
quality, smooth faders. These control individual source
levels in the mix.
8. Channel Cue Assign/PFL pushbuttons are used to
route channel audio to the Monitor Section. The channel
input faders do not control the Cue volume. When the Cue
button is pushed you get Pre Fader Listen(PFL). In addition,
when these buttons are depressed the third row of the LED
meter (20) will display the signal level of that channel on a
PFL basis. The level can be adjusted by using the Gain
control(1).
Numark - The Proven Leader in DJ Technology
©1997 Numark Industries 8 http://www.numark.com