Filter
Top Products
2
INT-150 Owners Manual
Please keep these instructions and heed all warnings.
Use product only for intended function.
For your protection please read the following:
Water and moisture: Electrical devices should not be used near water
(as per example, near a bathtub, washbasin, kitchen sink, laundry tub, wet
basement or swimming pool. ) Care should be taken such that objects do
not have the opportunity to fall, and that liquid is never spilled onto or into
the device enclosure through openings.
Power Sources: An electrical device must be connected to a mains power
source in strict accordance with the supplied product owners manual.
Please verify that the AC mains voltage specified in the product manual
match those requirements indicated on the unit and the AC voltage
provided to your location by the power company. Unplug this apparatus
during lightening storms or when unused for long periods of time. To
completely disconnect this apparatus from mains power, disconnect the
power cord from the AC receptacle. The equipment power switch does not
provide adequate protection to be considered a service disconnect.
Grounding: Adequate precautions should be taken so that the grounding
provisions built into an electrical product are never defeated.
Power Cords: Pass Labs provides a power supply cord that meets all
legislated requirements for the market in which the product was originally
sold. If you choose to substitute an after-market product we urge you
to choose a polarized cord that is fully safety rated by the necessary local
authority. Under no circumstances defeat the safety purpose of any
polarized plugs. If the supplied power cord does not fit your power outlet;
consult a qualified electrician, never modify the plug.
Power Cord Protection: Power supply cords should be routed so that
they are not likely to be walked on, abraded, or pinched by items placed
on or against them, paying particular attention to cords where they enter
plugs or exit from a device. Never under any circumstance insert a cut or
damaged power cord into a mains power socket.
Power and Signal: Cables should never be connected / disconnected
with equipment powered up. Failure to heed this warning may cause injury,
damage or destroy equipment.
Ventilation: Power-amplifiers run hot, but you should be able to place
your hands on them without discomfort. You must allow for this heat
in installation, by providing for free air circulation around the product.
Electronics should not be subjected to sources of excessive radiant heat.
Excessive heat can shorten the life of the product and may cause the
electronics to self protect and shut down. Never block any ventilation
openings. Allow at least 6 inches of clearance around these products for
proper ventilation.
WARNING