Filter
Top Products
((1166)) RREEMMOOTTEE SSWWIITTCCHH
This eight-pin DIN connector is provided for connection of the PFC 3 footswitch (included). The
footswitch cable should be connected before the amp is powered up. See the FOOTSWITCH
section of this manual for explanation of footswitch operation.
((1177)) EEFFFFEECCTTSS LLEEVVEELL SSWWIITTCCHH
Selects the effects loop operating level: -10 dBV (0.3V RMS) when “out” and 0 dBV (1 V RMS)
when “in”.
((1188)) EEFFFFEECCTTSS SSEENNDD
Output for supplying signals to external low-level effects or signal processing equipment.
((1199)) EEFFFFEECCTTSS RREETTUURRNN
Input for returning signals from external low-level effects or signal processing equipment.
((2200)) PPRREEAAMMPP OOUUTT
The preamp out can be used to route the amplified signal from the preamp to a mixing console,
tape recorder, etc. Connect the preamp output to line-level inputs of other equipment using high
quality shielded cable. This patch does not affect operation of the amplifier.
((2211)) PPOOWWEERR AAMMPP IINN
Used to connect line-level signals to the power amplifier section. Connect the power amp input to
line-level output of other equipment using high quality shielded cable. This patch disconnects the
preamp section from the power amp section.
((2222)) DDAAMMPPIINNGG
This three-position switch allows for adjustment of the damping factor of the power amplifier.
Damping is the ability of an amplifier to control speaker cone motion after the signal disappears.
A higher damping factor (TIGHT) reduces cone vibration more quickly than a lower damping factor
(LOOSE). This switch works much like the Resonance and Presence controls found on other
Peavey amps, if they were to be turned simultaneously. If the Damping switch is changed, the
volume level of the amp will also change and may require re-adjustment of the volume.
((2233)) PPOOWWEERR
This three-position switch selects the power output level of the power amplifier. This switch
works like the T. Dynamics
®
control found on other Peavey amplifiers which provides for a more
pronounced tube power compression simulation at lower settings.
7
RReeaarr PPaanneell
Sticker area
Keep out
Serial
REMOTE
SWITCH
120V
60 Hz
300 WATTS
GND.
0
WARNING:
CAUTION
RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR.
AVIS:
TO RAIN OR MOISTURE.
ELECTRIC SHOCK DO NOT EXPOSE THIS EQUIPMENT
TO REDUCE THE RISK OF FIRE OR
TRANSTUBE 100 EFX HD
EFX
LEVEL
EFX
EFX
PRE AMP
OUT
PWR AMP
IN
SEND
RETURN
-10 dBV (.3V RMS)
0 dBV (1V RMS)
LOOSE
POWER
DAMPING
MEDIUM TIGHT
100W 50W 25W
SPEAKER OUTPUTS
100 WATTS RMS/40V RMS, 4 OHMS MIN.
SPEAKER JACKS PARALLELED
IMPEDANCE SELECTOR
4
16
8
R
1616 23 25 20 19 17
27 26 22 21 1824