Filter
Top Products
9
1
23
PRESET
PRESET PRESET
MODULATION
CHANNEL
DELAY
REVERB
PFC 3
DOUBLE-CLICK
TO STORE PRESET
EFX
SELECT
MODE
TM
28 30 31 32 33
34
3529
MMOODDEE SSEELLEECCTT
The PFC 3 footswitch operates in two modes: EFX Select mode and Preset Select mode. Pressing
the MODE SWITCH (28) selects between the two modes. The active mode is indicated by the
MODE LED (29). Illumination of the LED indicates EFX Select Mode; a dark LED indicates Preset
Select Mode. Controls and indicators 30-35 perform different functions relative to the active
mode.
PPRREESSEETT SSEELLEECCTT MMOODDEE
In this mode, all three switches control effects presets. Their corresponding LEDs indicate which
preset is active. Once desired settings are achieved utilizing the effects controls on the front
panel,
ddoouubbllee--cclliicckk oonnee ooff tthhee PPrreesseett sswwiittcchheess ((3300,, 3333,, oorr 3355)) ttoo ssttoorree tthhee sseettttiinnggss..
To return to the
last saved settings for a Preset, press the desired Preset switch once.
For a detailed explanation on creating and storing presets, refer to the TWEAK FEATURES section
of this manual on the following page.
EEFFXX SSEELLEECCTT MMOODDEE
NNOOTTEE::
When entering this mode, the current preset will remain active. In this mode, SWITCH 1
(30) selects between the Lead and Clean channels. The CHANNEL LED (31) will illuminate when
the Lead channel is active. SWITCH 2 (33) toggles between two effects and their respective
settings. This switch may be used as an on/off switch if one of the settings has no effects active.
To use the MODULATION LED (32) as a status indicator, the “off” (or lower setting) should be
made with the LED dark, and the “on” (or higher setting) made with the LED illuminated. SWITCH
3 (35) toggles between two reverb and delay settings. As with effects settings, this switch may be
used as an on/off for reverb and delay. Both functions change simultaneously when this switch is
depressed.
FFoooottsswwiittcchh