Filter
Top Products
10
AC POWER INLET (Power Cord Located Under Chassis)
This is the receptacle for an IEC line cord, which provides AC power tot the unit. Connect the line cord to
this connector to provide power to the unit. Damage to the equipment may result if improper line volt-
age is used. (See voltage marking on unit.)
Never break off the ground pin on any equipment. It is provided for your safety. If the outlet used
does not have a ground pin, a suitable grounding adapter should be used and the third wire should be
grounded properly. To prevent the risk of shock or re hazard, always make sure that the amplier and
all associated equipment is properly grounded.
NOTE: FOR UK ONLY
As the colors of the wires in the mains lead of this apparatus may not correspond with the colored mark-
ings identifying the terminals in your plug, proceed as follows: (1) The wire which is colored green and
yellow must be connected to the terminal which is marked by the letter E, or by the earth symbol, or
colored green or green and yellow. (2) The wire which is colored blue must be connected to the terminal
which is marked with the letter N, or the color black. (3) The wire which is colored brown must be con-
nected to the terminal which is marked with the letter L, or the color red.
To avoid the risk of electrical shock, do not place ngers or any other objects into empty tube sockets
while power is being supplied to unit.
HEADPHONE JACK (Envoy 110 ONLY)
This stereo 1/4” jack accepts a standard pair of headphones. Using this jack defeats the
output to the speaker making it ideal for quiet practice applications.
SPEAKER SIMULATED DIRECT OUTPUT
The signal produced in this convenient 1/4" direct output jack is specically voiced to accurately simu-
late speaker cabinet response. The output can be used for direct recordings or sent to a mixer or PA
system. Users can adjust output levels with the adjacent control knob (Bandit 112 Only).
Rear Panel
15
16
17
15
16 1714
15
17