Filter
Top Products
38
PRESET DEFINITION
Address Name Range (Decimal)
(Hex)
00 Model Selection High nib is Cabinet Model, 0-7
Low nib is Amp Model, 0-7
Clockwise rotation for both nibs:
0 = Red / 2x10
1 = 360 / 1x18
: : :
7 = Freddie K / Alloy 4x10
01 Hardware Control Bits 0-3,7 = <reserved>
4 = Compressor On
5 = Analog Overdrive On
6 = Tweeter On
02 <reserved> 0
03,04 Pre Gain (non-boost, boost) 1-33 (active when Analog Overdrive
enabled)
05,06 Low (non-boost, boost) 1-33
07,08 Mid (non-boost, boost) 1-33
09,0A Mid Shift (non-boost, boost) 1-33
0B,0C High (non-boost, boost) 1-33
0D,0E Post Gain (non-boost, boost) 0-33 (0 = reverb off)
0F,10 <reserved> 0
11,12 Speed/Adj (primary/off, secondary/on) 1-25
13,14 Depth (primary/off, secondary/on) 0-25 (0 = modulation off)
15 Effect Type 0-7 = Chorus, Flanger, Phaser,
Octave, Synth, Fretless, Funk Wah,
Distortion
16 Effect Tweak 1 1-25; 255=no tweak *(see below)
17 Effect Tweak 2 1-25; 255=no tweak *(see below)
18-1D <reserved> 0
1E EFX Mode Status Bits (Soft) High nib is <reserved>
Low nib is EFX mode status:
Bit 0 is Boost (on/secondary = high)
Bit 1 is <reserved>
Bit 2 is Effect On (on = high)
Bit 3 is Effect Alt. (on/secondary = high)
Values are automatically set with effect selection, adjust after to tweak. Available tweaks are shown in table below.
Tweak 1 Tweak 2
Chorus - Crossover Frequency
Flanger Delay Time Crossover Frequency
Phaser --
Octave Tone -
Synth Frequency Resonance
Fretless Frequency Resonance
Funk Wah Frequency Resonance
Distortion Low Rolloff Dry Level