Filter
Top Products
PFC‘"
10 Professional MIDI Foot Controller
5.0
CONNECTING THE PFC 10 PROFESSIONAL MIDI FOOT CONTROLLER
5.
I
WITH THE TUBE FEX OR TRANSFEX 212
When used with the Peavey Tube Fex or TransFex
212,
the only connection required is that of the
supplied
8-pin
DIN cable. This cable provides power from the Tube Fex or TransFex 212 to the foot controller,
as
well
as supporting bidirectional
MIDI
transmission.
Caution:
The
8-pin
cable
is
not
a standard MIDI
cable. It
should
not
be used with any equipment
other
than
the Tube Fex or TransFex 212. At this time, no MIDI standard exists for the transmission of
bidirectional MIDI data and power in a single cable.
5.2 WITH OTHER
MIDI
EQUIPMENT
When used with
MIDI
equipment
other than
the Tube Fex or TransFex 212, an optional 16
volt AC
1,000
mA
power supply must be used along with a
standard
5-pin
DIN MIDI cable. Plug the MIDI/REMOTE OUT
of the foot controller into the MIDI IN of the equipment being controlled.
6.0 USING THE CONTROLLER WITH THE TUBE FEX OR TRANSFEX 212
The PFC 10 Professional MIDI Foot Controller senses when it is connected to a Peavey Tube Fex or
TransFex 212. When it is not, it operates in a "Stand-Alone" mode. If you are using the Controller with
equipment
other than
the Tube Fex or TransFex 212, skip this section of the manual and go to section 7:
USING THE CONTROLLER AS ASTAND-ALONE MIDI CONTROLLER.
When you first turn the Tube Fex or TransFex 212 on, the Controller
will
display the following message
for a short time:
At this time, it is waiting for the rack unit to identify
itself
and its
MIDI
CHANNEL number. If the
controller is connected to a Tube Fex or TransFex
212,
you
will
not
haveto
do anything, and this screen
will
clear itself when the rack unit responds. After a few seconds, the controller will be in Program mode.
6. I PROGRAM CHANGE MODE
In this
mode,thecontroller
will
transmit program
changecommands.The
programsarearrangedinten
banks often programs. The ten NUMERIC buttons select the bank and the program within that bank. In this
manner, 100 programs can be selected: Banks 0 through 9 each have ten programs.
Peavey Electronics Corporation