Filter
Top Products
11
Front Panel
EFX TIME
This control adjusts the time of the particular reverb or delay.
EFX TO MONITOR
This control adjusts the amount of effects signal sent to the monitor mix, allowing effects to be
heard from the stage via the monitors. Keep this control as low as possible.
EFX TO MAIN
This control adjusts the amount of effects sent to the main front-of house mix. Remember: A little goes
a long way!
FLS
®
FEEDBACK LOCATING SYSTEM
When feedback occurs‚ the corresponding LED of the frequency band that is feeding back will illumi-
nate over the slider to be adjusted. Slowly bring the corresponding slider down until the feedback is
gone. The LED will remain illuminated for a few seconds after the feedback is gone. When the feedback
doesn’t return‚ all the LEDs will become active again, acting as a normal EQ.
GRAPHIC EQ
These 7-band EQs are designed for 12 dB of cut or boost. The equalizers are placed before the Preamp
outputs; therefore‚ the Main and monitor preamp outputs are post-EQ.
19
22
23
20
21
22
23