Filter
Top Products
24
ENGLISH
ENGLISH
BELT-CLIP TRANSMITTER PX 1000
BELT-CLIP TRANSMITTER EQUIPPED WITH:
• ON/OFF switch for transmitter activation.
• MUTE switch.
• A green LED indicating the battery charge status.
• A trimmer to adjust the input sensitivity.
• A red “PEAK” LED
(indicating the maximum admissible level of the input signal).
• A socket with screw-lock connector for the microphone.
USE:
• (!) Make sure the power switch is in the OFF position before inserting
the battery.
• Connect a clip-on (“Lavalier”) mic. LA 1000 or a headworn mic. HE 1002
by inserting the mini-jack into the transmitter socket and tightening it
thoroughly.
• Remove the cover of the battery compartment using a coin or a
screwdriver.
• Insert a 9 V alkaline battery according to the polarity indications (+/-)
printed on the bottom.
• Put the cover back on the battery compartment and press it down to
secure it in its seat.
• Switch on the transmitter by setting the ON/OFF switch to ON. The green
LED lights up (the LED stays lit during normal operation; it flashes when
the battery is low and should be replaced).
• Make sure the MUTE switch is set to ON.
• Check the transmitter is working correctly: one of the two green LEDs
A/B on the respective receiver should be lit.
• Adjust the input sensitivity appropriately (using a screwdriver) using the
SENS trimmer located on the upper part of the transmitter (during normal
use, increase the sensitivity so the red “PEAK” LED flashes occasionally
but does not remain lit continuously).