Revolabs 03-ELITEEXEC8-EU Microphone User Manual


 
43
to muting and unmuting microphones based on the group settings. The
microphone symbols reflect the current mute status for each microphone.
If it is preferable to view microphones in numerical order, rather than by group,
the “View By:” option at the top right of the page will change the view mode.
Beside this option, the Manage Groups button will navigate to the Group
Management page, also found under the Audio Management menu.
Both the Monitor and Microphone Audio pages have a microphone control
dropdown menu accessible from the microphone tables. To open the menu,
hover over the desired microphone’s column and a black-on-white arrow
button will appear in the upper right corner. Clicking the arrow opens the
microphone control menu, allowing access to the following options:
Unpair Mic – The selected microphone will be unpaired from the Elite
Base Unit. The microphone will not relink if turned back on.
Restart Mic – The selected microphone turns off and reboots, relinking
after it turns back on.
Enter Standby/Leave Standby – All microphones in the same group as
the selected microphone will enter standby mode. In this mode, the
microphone will show a single Yellow blink every 10 seconds. Standby
mode uses minimal power, and can be turned off by touching the
microphone’s mute or selecting “Leave Standby” in the microphone
control dropdown.
Power down Mic – The selected microphone is powered off, but not
unpaired. Turning the microphone back on will cause it to relink.