Filter
Top Products
90
NOTE: Use only microphones compatible with the wiring of the TA4
adapter.
NOTE: The TA4 adapter provides 2.7 volts of phantom power.
To use the Elite Wireless TA4 (mini XLR) Adapter:
1. Remove the mini XLR Adapter from the Charger Base.
2. Attach a microphone to the top of the adapter and clip the end to clothing or
a belt. Make sure that the microphone and adapter are attached securely.
3. After positioning the microphone at the distance it will be used at, unmute
it and go to the Microphone Management page of the Web UI. The TA4
adapter’s column will have a Pre-Amp gain setting once the adapter is
paired. This slider will allow different types of microphones to be integrated
with the Executive Elite sound system. Select the highest setting on the
pre-amp where clipping is not observed, to allow for the highest signal to
noise ratio.
4. Based on the mute behavior defined for the adapter in the local web UI,
mute or un-mute the microphone by pressing the mute button on the
adapter (confirmed by flashing green or flashing red LEDs, respectively). In
push-to-talk mode, press the mute button and keep the finger there to
unmute the microphone. Removing the finger from the mute button will
mute the microphone again.
5. To turn the mini XLR adapter off, return the unit to the Charger Base or
press and hold the mute button for about 10 seconds until the LED turns
solid red, then release the button. The adapter can also be turned off from
the local web UI or the room control interface. In push to talk mode the
adapter cannot be shut down using the mute button.
NOTE: Do not place the TA4 adapter into the Charging Base while the
handheld microphone is still attached. Place only the adapter in
the Charging Base.
If the adapter is placed too far away from the Remote Antenna (depending on
the RF power setting this can be 300 feet, 90 meters, or more from the Remote
Antenna) the connection will be dropped (LEDs flash red-yellow-green-yellow)
and the microphone will mute. After 15 seconds the adapter will beep , and will
continue beeping every 30 seconds to indicating that it is out of range.
Move the adapter closer to the Remote Antenna and the connection will
automatically be re-established to its original state, and the beeping will cease.
Otherwise, the adapter will continue beeping until it turns off after about 15
minutes.