Filter
Top Products
FR-1 V-Accordion
12
Attaching the straps
(1) Unpack the straps.
(2) Put the FR-1 on a stable surface.
The connection panel must face down.
(3) Slide the
upper end of
one strap
through the
holder ring
(see the
illustration).
The upper
end is the
part with the
Velcro portions and the clip.
(4) Fasten the strap’s upper part to the Vel-
cro layer below it.
(5) Close the
security clip
to ensure
that the
strap cannot
come loose.
(6) Repeat steps
(3)~(5) for
the other
strap.
The upper strap ends should look as fol-
lows:
(7) Turn the FR-1 around (with the con-
nection panel on the left side, see
below).
(8) Slide the
lower end of
one strap
through the
holder ring
as shown.
(9) Slide the
strap end
through the
upper eyelet
of its plastic
buckle (see
the illustra-
tion).
(10) Turn the
strap end
around and
insert it into
the lower
eyelet, then
pull it tight.
(11) Slide the
plastic clip
over the
loose and
long lower
strap ends to
secure the
strap.
Note: You may want to adjust the length first
to suit your preference.
(12) Repeat steps (8)~(11) for the other
lower strap end.
FR-1_QuickStart.book Page 12 Thursday, January 15, 2009 7:05 PM