Filter
Top Products
7
Important Notes When Moving the Unit
This equipment is heavy (weighing 44 kilograms), so to prevent
injury and other safety hazards due to accidental toppling, drops,
or falls, at least two persons should work together to carry the
unit when moving it.
fig.unpan.eps
When moving this equipment, carry it while securely gripping
the left and right handles as shown in the figure.
fig.handle.eps
Using the included casters can be convenient on level surfaces.
The KC-880 comes with casters, which can be useful when
moving the unit.
When attaching or removing the casters, give attention to the
following points.
• Carry out the operation at a location that is level and stable.
• To ensure safety, at least two persons should work together
to carry out the operation.
• Exercise care to keep fingers or feet from being pinched or
pinned.
• When attaching or removing the casters, to avoid damaging
the unit or the floor surface, place stacked newspapers or the
like under the unit.
• When placing the unit on the floor on its side, handle with
care to avoid dropping it, or allowing it to fall or tip over.
ig.caster.eps
1. Place the KC-880 on the floor on its side as
shown in the figure.
2. Attach the casters to the unit (or detach the
casters).
3. Return the unit to its upright position.
Use and Handling of the Casters
Attaching and Removing the Casters
Turning the Power On and Off
* Once the connections have been completed, turn on power to your
various devices in the order specified. By turning on devices in the
wrong order, you risk causing malfunction and/or damage to
speakers and other devices.
* Before switching off the power, lower the volume on each of the
devices in your system and then TURN OFF the devices in the
reverse order to which they were switched on.
1. Make sure that all volume controls on the KC-
880 and connected devices are set to 0.
2. Turn on all the devices connected to the KC-
880’s input jacks (CH 1 through CH 4 and AUX
IN/MONITOR IN).
3. Turn on the KC-880.
4. Switch on any equipment connected to the
KC-880’s LINE OUT jacks.
5. Adjust the volume levels for the devices.
* This unit is equipped with a protection circuit. A brief interval (a few
seconds) after power up is required before the unit will operate
normally. For protection from sudden big sound, always make sure
to have the volume level turned down before switching on power.
Even with the volume all the way down, you may still hear some
sound when the power is switched on, but this is normal, and does
not indicate a malfunction.
* If you need to turn off the power completely, first turn off the
[POWER] switch, then unplug the power cord from the power outlet.
Refer to
“Power Supply” (p. 6).
KC-880_e.book 7 ページ ２００９年１月６日 火曜日 午前１０時２６分