Filter
Top Products
8
Quick Guide
The Quick Guide describes required settings and basic operations.
Making the Connections
For more information about making the connections, refer to
“Connect your KC-880” (p. 9).
1. Make sure all devices are turned off.
2. Connect the external devices.
3. Turn down all volume controls on the KC-880
to zero.
fig.QG-01.eps
4. Place the EQUALIZER controls at the center
position (0).
fig.QG-02.eps
5. Switch off all [EFX] buttons.
fig.QG-03.eps
6. Switch off the AUX IN/MONITOR IN [MUTE]
button.
fig.QG-04.eps
Switch on the Power
* Once the connections have been completed, turn on power to your
various devices in the order specified. By turning on devices in the
wrong order, you risk causing malfunction and/or damage to
speakers and other devices.
1. Turn on the devices connected to the input
jacks.
2. Turn on the KC-880.
fig.QG-05.eps
3. Turn on the devices connected to the output
jacks.
Turn off the power in the reverse order.
1. Adjust each channel’s volume knob to its
center setting (5).
If you’re using a microphone, turn the CH1 volume knob to
the “MIC” range.
Lower the volume levels for channels you’re not using.
fig.QG-06.eps
2. While playing sound on the connected
devices, slowly turn the [VOLUME] knob to
adjust the overall volume level.
fig.QG-07.eps
3. Use the volume knobs for the respective
channels to adjust the volume balance for the
connected devices.
fig.QG-08.eps
4. Use the [VOLUME] knob and the EQUALIZER
controls to adjust the overall volume level
and sound quality.
fig.QG-09.eps
1. Press the [EFX] button for the channel to
which you want to apply the effect.
fig.QG-10.eps
2. Use the [EFX] knob to adjust the effect and its
depth.
fig.QG-11.eps
Getting Ready
on
on
Try Playing Sound from the Built-in
Speakers
Try Applying Built-in Effects
When using a mic
on
KC-880_e.book 8 ページ ２００９年１月６日 火曜日 午前１０時２６分