Filter
Top Products
4
Panel Descriptions
POWER Indicator
This indicator shows whether the power is on or off,
and also functions as a battery-check indicator.
* When the indicator starts to dim or fails to light, the
batteries are exhausted. When this occurs, install new
batteries. For instructions on replacing the batteries, refer
to “Installing Batteries” (p. 6).
* The power comes on when a plug is inserted into the
INPUT R/MONO jack, and goes off when it is
unplugged.
START/STOP Indicator
This lights up when the ef-
fect is on.
TAP Indicator
This lights up when the TAP pedal
is pressed.
TAP Pedal
You can set the tempo by tapping it in
with this pedal.
You can jump back to the beginning of
the slice pattern measure by pressing the
TAP pedal while the TAP indicator is off.
When this is pressed during playback of
a slice pattern or phrase, the SL-20
returns the slice pattern or phrase to the
beginning and starts playback from there.
* You cannot set the tempo with the SL-
20 while MIDI clock is being received.
“Using the TAP Pedal to Cue the
Slice Pattern” (p. 12)
“Setting the Tempo with the TAP
Pedal” (p. 12)
“Recording/Loop Playback” (p. 13)
START/STOP Pedal
This alternately switches the effect on or
off each time the pedal is pressed.
The slice pattern plays when the effect is
switched on.
Pressing and holding down the pedal for
at least two seconds switches the SL-20 to
recording standby. After recording, the
SL-20 switches to loop playback.
“Recording/Loop Playback” (p. 13)
* When switching effects off, the effect
switches off at the time the pedal is
released.
* When the effects are off, sound arriving at
the INPUT jack is output without change.
PLAY Indicator
This lights up during loop
playback of phrases.
REC Indicator
This flashes when the SL-20
is in recording standby and
lights steadily during
recording.
SL-20_e.book 4 ページ ２００８年３月２８日 金曜日 午前８時２８分