Roland TD-6/6V Musical Instrument User Manual


 
SMARTRIGGER USERS GUIDE
Version 1.4
1/30/2005
©2004 All Rights Reserved. http://www.smartrigger.com
Included Ride Y Cable splits stereo cable into 2 mono inputs
Plug the black TIP plug into the RIDE input and the orange RING plug into the EDGE
input. This places the bow ride sound on the Ride input and the bell ride sound on the
Edge input. Make sure you have a ride bow sound assigned to the HEAD of the Ride
input and a bell sound assigned to the HEAD of the Edge input.
Alternatively, you can use one of the AUX inputs for the ride without the Y cable. The
AUX inputs are dual-piezo inputs like the toms and snare and allow for dual piezo
stereo triggers like the Smartrigger CY-16R. This frees up inputs 10 and 11 (Ride and
Edge) for two additional cymbals. Make sure to select PD-120 for the input type on the
AUX input as this will allow the bell and bow sounds to be triggered, then select a ride
bow instrument and assign it to the HEAD of the AUX input and a ride bell instrument
and assign it to the RIM of the AUX input. Make sure you have a ride bow sound
assigned to the HEAD and a bell sound assigned to the RIM of the AUX input.
Settings for the Roland TD-10
Type
Sens
Thold
Curve
Scan
ReTrg
Can.
Mask
Xtalk
Splash
PD7
3
2
Linear
0.3
3
12
30
Crash
PD7
3
2
Linear
0.3
3
12
30
China
PD7
3
2
Linear
0.3
3
12
30
Ride Bow
PD7
5
2
Linear
0.3
3
12
40
Ride Bell
PD7
2
1
Linear
0.3
3
12
30
Hi Hat
PD-7
3
2
Linear
0.3
3
12
30
Notes for using the Smartrigger CY-16RC3 Triple Zone Crash/Ride Cymbal:
Connect one stereo cable from the bow trigger jack to the RIDE input on your module.
Connect the other stereo cable from the bell trigger jack to the AUX 1 input on your
module.
IMPORTANT!!! Make sure you have two inputs set to trigger the appropriate sounds for
each kit
o Ride Input HEAD = Ride Bow Sound
o Ride Input RIM = Ride Edge Sound