Filter
Top Products
SMARTRIGGER USERS GUIDE
Version 1.4
1/30/2005
©2004 All Rights Reserved. http://www.smartrigger.com
Settings for the Roland TMC-6
Type
Sens
Thold
Curve
Scan
ReTrg
Can.
Mask
Xtalk
Splash
CY
10
4
Lnr
2.5
8
8
40
Crash
CY
10
4
Lnr
2.5
8
8
40
China
CY
10
4
Lnr
2.5
8
8
40
Ride Bow
CY
8
4
Lnr
2.5
8
8
40
Ride Bell
CY
12
0
Lnr
2.5
8
8
40
Hi Hat
CY
10
4
Lnr
2.5
8
8
40
Notes for using the Smartrigger CY-16RC3 Triple Zone Crash/Ride Cymbal:
Connect one stereo cable from the bow trigger jack to the RIDE input on your module.
Connect the other stereo cable from the bell trigger jack to any other available input on
your module.
IMPORTANT!!! Make sure you have the two inputs set to trigger the appropriate sounds
for each kit
o Ride Input HEAD = Ride Bow Sound
o Ride Input RIM = Ride Edge Sound
o Other Input HEAD = Ride Bell Sound
o Other Input RIM = Ride Edge Sound (Same as Ride RIM input)
Notes for using the Smartrigger CY-16R Dual Zone Ride Cymbal:
Use the included Y cable on the module end of the ride’s stereo cable. Plug the black
TIP plug into the any input (other than #2) and the orange RING plug into any other
input (other than #2).
Alternately, you can use input #2 only which is a stereo input (the only one on the TMC-
6) without the Y cable. Use the following settings if you connect the Ride to input #2.
NOTE: You MUST set the pad type to P12 in order to achieve the Bow and Rim sounds,
you will have to adjust the Head and Rim settings independently.
Type
Sens
Thold
Curve
Scan
ReTrg
Can.
Mask
Xtalk
Ride
(Head)
8
4
Lnr
2.5
8
8
40
Ride
(Rim)
P12
12
0
Lnr
2.5
8
8
40