Filter
Top Products
If you’ve had some prior experience using wireless systems, these QuickStart
instructions will get you up and running with your AirLine Synth UHF guitar system in
a matter of minutes! Detailed instructions for setting up and using your AirLine Synth
system can be found on page 15 of this manual, and the “Guided Tour” sections on
pages 4 - 11 provide full descriptions of all AirLine component controls and displays.
1. Unpack the AR300 receiver and AG300
transmitter and configure the AG300 for
Fender Strat™ or flat jack style guitars.
If you need to change the phone plug
configuration, simply remove the
thumbscrew, unscrew the plug and
reinstall the two components while
swapping their positions.
2. Physically place the AR300 receiver on your
amp or in front of you. Extend its antennas
vertically and spread the tips horizontally
outwards.
3. Set the power switch on your AG300
transmitter to the “off” position (away from
the arrow) and place a fresh AA battery
in it. Then turn the transmitter back on
momentarily; its LED will flash once and then go off if the battery is sufficiently
strong. Once battery strength is verified, turn the transmitter off again, then put it
aside for now.
4. Connect the included AC power supply to the rear of the AR300 and then to an
available wall socket. Turn the AR300 on momentarily to confirm that the unit has
power. Then turn the AR300 power off.
5. Turn your amplifier or mixer off and make the physical cable connection between
an audio input and the AR300 output jack.
6. Turn the Level knob on the AR300 completely counterclockwise, then turn its
power on.
QuickStart
2