Filter
Top Products
19
XP1000 • Portable PA System
If the handheld transmitter and
receiver have not been previously
paired, press and hold the button on
the RXD1 receiver for >5 seconds,
until it begins to flash.
Press and hold the Power button on
the handheld transmitter >5 seconds.
This will put both components into
pairing modes. Once the receiver and
transmitter communicate and sync,
the LEDs on both units will light
steady and will be ready for operation.
Raise the MASTER LEVEL control and
speak or sing into the mic at a normal
performance level while raising the
Channel 4 LEVEL control until the
desired level is reached.
If you hear distortion check the
LIMITER LED. If it is lit red, turn
down the channel 4 LEVEL on
the XP1000 until it lights only
occasionally during loud sounds. If
you still hear distortion, unscrew the
microphone body and use the supplied
plastic screwdriver to turn the Gain
control in the HXD1 transmitter slowly
counterclockwise until the distortion
disappears.
Conversely, if you hear a weak, noisy
signal at the desired volume level
(and with the WIRELESS control of
the XP1000 turned fully clockwise),
use the supplied plastic screwdriver
to turn the Gain control in the HXD1
transmitter slowly clockwise until the
signal reaches an acceptable level.
Stage XPD1 Wireless System (Optional)