Filter
Top Products
Using the receiver
21
To transfer the parameters:
̈ Switch the transmitter and the receiver on.
̈ Press the button ³ on the receiver.
“Sync” appears on the display panel of the receiver.
̈ Place the infra-red interface of the transmitter (see the instruction
manual of the transmitter) in front of the infra-red interface · of the
receiver.
The parameters are transferred to the transmitter. When the transfer
is completed, “ ” appears on the receiver’s display panel. The receiver
then switches back to the current standard display.
To cancel the transfer:
̈ Press the STANDBY button ² on the receiver.
“ ” appears on the display panel of the receiver. “ ” also appears if no
suitable transmitter was found.
·
³
·
³