Filter
Top Products
E-14
HT-SB200
2008 December 17
HT-SB200_EN-UK_rev4.fm
ENGLISH
EN (9)
References
Troubleshooting chart
Many potential problems can be resolved by the owner without
calling a service technician.
If something is wrong with this product, check the following
before calling your authorised SHARP dealer or service centre.
General
Remote control
Condensation
Sudden temperature changes, storage or operation in an
extremely humid environment may cause condensation inside
the cabinet or on the transmitter on the remote control.
Condensation can cause the speaker to malfunction. If this
happens, leave the power on until normal operation is possible
(about 1 hour). Wipe off any condensation on the transmitter
with a soft cloth before operating the speaker.
If problem occurs
When this product is subjected to strong external interference
(mechanical shock, excessive static electricity, abnormal supply
voltage due to lightning, etc.) or if it is operated incorrectly, it may
malfunction.
If such a problem occurs, do the following:
1.
Set the
speaker
to the stand-by mode and turn the power on
again.
2. If the speaker is not restored in the previous operation,
unplug and plug in the speaker, and then turn the power on.
Symptom Possible cause
No sound is heard. z Is the input signal (selection) set
properly?
z Is the volume level set to “0”?
Noise is heard
during playback.
z Move the speaker away from any
computers or mobile phones.
When a button is
pressed, the
speaker does not
respond.
z Set this speaker to the stand-by
mode and then turn it back on.
The power is not
turned on.
z Is the speaker unplugged? (Refer to
page 11.)
z The protection circuit may be
activated. Unplug and plug in the
power lead again after 5 minutes or
more.
Symptom Possible cause
The remote control
does not operate
properly.
z Is the battery polarity correct?
z Is the battery dead?
z Is the distance or angle incorrect?
z Are there any obstructions in front of
the speaker?
z Is there a strong light shining on the
remote sensor?
z Is the remote control for another
equipment used simultaneously?
Symptom Possible cause
The speaker cannot
be turned on with
the remote control.
z Is the AC power lead of the speaker
plugged in?
z Is the battery inserted?
TV cannot be
operated with the
remote control.
z Depending on the model, some or all
functions may not be operable using
the remote control of this speaker. In
this case, use the remote control
supplied with the TV.