Filter
Top Products
9
1
7
6
5
4
3
2
1
9
HT-SL50
E-11
2011 April 8
Troubleshooting chart
Many potential problems can be resolved by the owner
without calling a service technician.
If something is wrong with this product, check the following
before calling your authorised SHARP dealer or service
centre.
Sudden temperature changes, storage or operation in an
extremely humid environment may cause condensation
inside the cabinet. Condensation can cause the unit to
malfunction. If this happens, leave the power on until
normal playback is possible (about 1 hour). Wipe off any
condensation on the transmitter with a soft cloth before
operating the unit.
When this product is subject to strong external interference
(mechanical shock, excessive static electricity, abnormal
supply voltage due to lightning, etc.) or if it is operated
incorrectly, it may malfunction.
If the unit is not restored in the previous operation,
unplug and plug in the unit again
or
unplug all component connected and plug in again.
Maintenance
Periodically wipe the cabinet with a soft cloth.
Caution:
● Do not use chemicals for cleaning (petrol, paint thinner,
etc.). It may damage the cabinet finish.
● Do not apply oil to the inside of each component. It may
cause malfunctions.
■ General
Symptom Possible cause
● No sound is heard. ● Is the input signal
(selection) set properly?
● Is HDMI compliant
equipment being used?
● Is the HDMI cable
connected correctly?
● Is the HDMI cable of the
correct type being used?
(ver 1.4 with ARC)
● Does the sound input
support PCM signal?
● Do not connect or
disconnect an HDMI cable
whilst power is on. This
may lead to operation
problems.
● Noise is heard
during playback.
● Move the speaker away
from any computers or
mobile phones.
● The power is not
turned on.
● Is the unit unplugged?
● The protection circuit may
be activated. Unplug and
plug in the power lead
again after 5 minutes or
more.
● Volume cannot be
controlled.
● Check if the HDMI CEC is
enabled.
● For headphone or RCA,
TV setting (VARIABLE) is
required.
● 3D images not
displayed on the TV.
● Depending on the TV and
Video component, 3D
images may not be
displayed.
Check the operation
manual of the respective
component.
■ Condensation
■ If problem occurs during operation
■ Cleaning the cabinet