Shure 27C8642 Microphone User Manual


 
6
ENGLISH
SPECIFICATIONS AND INFORMATION
Specifications
RF Carrier Frequency Range
169.445 to 216.000 MHz
Working Range
100 m (approximately 300 ft) under typical conditions.
Audio Frequency Response
50 to 15,000 Hz, ±2 dB
Audio Output Level (±15 kHz deviation, 1 kHz tone)
1/4 inch connector (into 3 kW load)
-8.8 dBV (Hi Z)
Audio Connectors
Gain Adjustment Range
T1: 40 dB
T2/14A: 25 dB
RF Power Output
T1, T2/14A: 50 mW maximum (complies with FCC and IC
regulations)
RF Sensitivity
-101 dBm typical
System Distortion (ref. ±15 kHz deviation, 1 kHz modulation)
0.7%
Power Requirements
T1, T2/14A: 9V alkaline battery (Duracell MN1604 recommend-
ed). 8.4V Nicad (rechargeable) are optional but not recom-
mended.
T88: 12 Vdc (PS20, 120Vac; PS20E, 230 Vac Power Supply)
Current Drain
T1: 31 mA average (40 mA max)
T2/14A: 30 mA average (35 mA max)
T88: 160 mA average (195 mA max)
Operating Temperature Range
-20
° to 50°C (-4° to 122° F). NOTE: Battery characteristics may
limit this range.
Overall Dimensions
T1: 82.6 mm H x 63.5 mm W x 26.2 mm D
T2/14A: 241 mm L x 50.8 mm Dia.
T88: 44 mm H x 349 mm W x 194 mm D
Net Weight
T1: 79.5 g without battery
T2/14A: 294.8 g without battery
T88: 435 g
Certification
T1, T2: Type-accepted under FCC Parts 90 and 74; IC certified
under TRC-78
T88: Approved under the Notification provision of
FCC Part 15
PS20 Power Supply: Conforms to safety standard UL1310.
Canada/CSA 22 2 No. 223.
PS20E Power Supply: Conforms to safety standard EN 60065
PS20UK Power Supply: Conforms to safety standard
EN 60065.
Furnished Accessories
Plastic Screwdriver ...........................................65A1659
Swivel Adapter (hand-held only)....................... WA370A
Anti-Roll Device (hand-held only) .....................66A8043
Optional Accessories
Microphone Adapter Cable (T1)...........................WA310
4-Pin Female Mini Connector TA4F (T1) .............WA330
In-Line Audio Switch (T1).....................................WA360
1.8 Meter (6 ft.) Receiver-Mixer Cable.................WA410
6.1 Meter (20 ft.) Antenna Extension Cable.........WA421
Replacement Parts
14A Cartridge with Grille.........................................R200
AC Adapter ................PS20 (120 Vac)/PS20E (230 Vac)
Grille (T2/14A)....................................................RK143G
Belt Clip (T1)...................................................53A8247A
1/4 Wave Antenna ............................................90A8380
Model: T88 T1
Connector Type: 1/4-inch
phone plug
(female)
4-Pin miniature
connector
(TA4F)
Configuration: active
unbalanced
active
unbalanced
Actual
Impedance:
3 kW 18 kW
with lavalier
Maximum
Input Level:
-12.2 dBu
Maximum
Output Level:
0 dBu -
Pin
Assignments:
Tip = hot
sleeve = ground
pin 1= ground
pin 2 = +5 V
pin 3 = audio
pin 4 = through
20 kW resistor
to ground
Phantom Power
Protection:
yes -
Voltage: -+5 V
27pF
20K
27pF
+5V
AUDIO
GROUND
T1MICJACKBOARD
2
1
4
500
500
MICROPHONE
ELEMENT
3
2
1
3
4
NOTE: LAVALIERMICTIESPINS3AND4TOGETHER;GUITARCABLEDOESNOT.
T1 Pin Connections
T88 Output Wiring (1/4 inch male plug to output connector)
SLEEVE
TIP +
This symbol indicates that dangerous voltage constituting a
risk of electric shock is present within this unit.
This symbol indicates that there are important operating and
maintenance instructions in the literature accompanying this unit.