Filter
Top Products
16
GB
1 Press SAVE to activate the save mode.
The program number starts blinking.
(A previously saved program name appears in the
display.)
2 Turn the rotary encoder to select the
program number (201~400) where you
want to save the effect.
(A previously saved program name appears in the
display.)
3 Press EDIT PARAMETER / to move the
cursor to the program name.
The name of the program you edited appears in the
display and the first character starts to blink.
Saving your Program
New programs created by changing effect blocks, effect structures, and effect parameters can be stored in memory for later
use. You can store up to 200 different user programs using program numbers 201~400.
4 Turn the rotary encoder to select a
character.
5 Use EDIT PARAMETER ? or / to move
the cursor into place for the next
character.
Repeat steps 4 and 5 to enter up to 12 characters.
6 When you’ve finished entering the
characters, press SAVE (or ENTER (TAP)).
7 The unit will ask for confirmation before
saving the program.
To execute the save operation, press ENTER (TAP).
If you press ENTER (TAP), “Writing...” appears
momentarily, the program is saved, and the unit
switches back to the play mode.
If you do not want to save the program, press EXIT.
If you press EXIT, the unit returns directly to the play
mode without saving the program.
Editing a Program
Display Rotary encoder
ENTER
(TAP)
EXIT
SAVE
EDIT PARAMETER
? /
Save:
201 Super Reverb
Save:
300 StereoChorus
Save:
300 Super Delay
Save:
300 Xuper Delay
Save:OK?
N[EXIT]/Y[ENTER]
300 X My Program
FxA:24/ FxB:31