Filter
Top Products
11
How to Control AV Equipment from the SRP-X700P
The SRP-X700P can control the Sony equipment connected to the CONTROL S OUTPUT1 through 4 terminals. The functions which can be
operated are as follows.
Note that the functions of REC, POWER ON, and POWER STANDBY cannot be operated from the supplied software SRP-X700P Manager
and User Control Panel, to prevent the system from malfunctioning.
Use the supplied IR transmitter VM-50 to control the Sony equipment that is not equipped with the
CONTROL S terminal.
• Confirm location of the remote control signal receptor part of the Sony equipment that you want to control, and fix the supplied IR
transmitter VM-50 with a both-sided adhesive tape as shown below.
Setting Requirements
• Operate the SRP-X700P Manager or the User Control Panel to confirm that it can control the Sony equipment. If they cannot control the
equipment, change position of the supplied IR transmitter VM-50 until they can control the equipment.
Connecting the Speaker
Speaker connection method changes depending on the operating mode.
When the “70 V LINE” mode is selected, the output signal becomes monaural. Connect the (+) terminal of a speaker to the (+) terminal (red)
of SPEAKERS CH-1 and the (–) terminal of a speaker to the (+) terminal (red) of SPEAKERS CH-2.
PREV. NEXT STOP REW. PLAY F.F. PAUSE REC
POWER POWER
ON STANDBY
aaaaaaaaaa
——aaaaaaaa
aaaaaaa— aa
MD
CD-R Audio
VTR1 (Beta)
VTR2 (8mm)
VTR3 (VHS)
VTR4 (DV)
CD
DVD
Install the VM-50 inside a rack. Recess the
IR receiver behind the IR LED by more than
10 cm. Install the IR receiver in the location
that is within the range of 20 cm higher and
20 cm lower than the IR LED (as shown by
the dotted line of the illustration). The IR
receiver of the equipment should be located
more than 5 cm far from the IR LED in the
right and left.
Note
If any screening object is placed in between
the IR LED and the IR receiver, the infrared
ray is blocked to disable control of the
external equipment.
CH-1
+
+
+
+
CH-1
–
–
–
+
–
–
CH-2
CH-2
CH-1
+
+
CH-1
–
–
CH-2
CH-2
Impedance
4Ω to 16Ω
Impedance
32Ω to 10kΩ
• Connecting speakers with
low impedance [Lo imp.]
• Connecting speakers with
high impedance [70 V LINE]
∗ The notation in [ ] is displayed in the
SRP-X700P Manager.
Impedance
1 kΩ
3.3 kΩ
10 kΩ
Power applied to
each speaker
5 W
1.5 W
0.5 W
Number of speakers
you can connect
30
100
300
5cm 5cm
20cm 20cm
10cm
VM-50
VM-50
View from the top
IR LED
Front panel side
of the equipment
View from the front
IR receiver
Service area
The table below shows the number of speakers that can be connected in the high impedance [70 V LINE] mode.