Filter
Top Products
5
7 Power amplifier indicators
• PROTECTION indicator
The PROTECTION indicator lights in red when the
protection circuit of the internal power amplifier works.
• CLIP indicator
The CLIP indicator lights in red when the output level of the
internal power amplifier is excessive such that the output
signal is distorted.
Notes
When the PROTECTION indicator lights
The protection circuit operates (PROTECTION indicator
lights) and the speaker and amplifier are protected from
damage by decreasing or cutting the output signal in case of
the following:
• If the temperature of the heat sink inside the amplifier
exceeds the specified value.
The connected speaker impedance is too low.
Air intake and exhaust holes (on the right and left sides of
the SRP-X700P) are choked by dust.
• The SPEAKERS terminal is short-circuited.
In such a case, turn the POWER button to the OFF position
and remove the cause of the fault before using the unit
again.
• If DC voltage appears in the SPEAKERS terminal due to
failure.
Turn off the POWER button and contact your local Sony
Sales office or Dealer.
8 Level meters
Displays the output signal levels of the LINE OUTPUT 1 to
LINE OUTPUT 8 terminals, with the 5-point LED.
9 LOCK indicator
The LOCK indicator lights in red when the SRP-X700P
Manager locks the front panel to prevent illegal operation.
While lit, you cannot operate from the front panel.
0 RS-232C indicator
The RS-232C indicator lights in green when a command is
sent or received through the RS-232C remote terminal.
qa USB indicator
The USB indicator lights in green when a command is sent or
received through the USB terminal.
qs USB terminal
Connect the SRP-X700P to a computer in which the supplied
software (SRP-X700P Manager and User Control Panel) is
installed using the USB terminal.
qd SCENE RECALL button
You can recall the scene memories A to D.
Use the SRP-X700P Manager to assign the scenes to the scene
memories A to D.
By default, the scene memory A is assigned to scene No. 1, the
scene memory B is assigned to scene No. 2, the scene memory
C is assigned to scene No. 3 and the scene memory D is
assigned to scene No. 4.