Filter
Top Products
2
For UTX-B1 and UTX-H1
Transmitters
Owner’s Record
The model and serial numbers are
located at the rear or on the bottom of
the unit. Record the model and serial
numbers in the space provided below.
Refer to these numbers whenever you
call upon your Sony dealer regarding
this product.
Model No. _____________________
Serial No. _____________________
Notice for customers in the
U.S.A.
Use of Sony wireless devices is
regulated by the Federal
Communications Commission as
described in Part 74 subpart H of the
FCC regulations and users authorized
thereby are required to obtain an
appropriate license.
You are cautioned that any changes or
modifications not expressly approved
in this manual could void your
authority to operate this equipment.
IMPORTANT NOTE: To comply
with the FCC RF exposure compliance
requirements, no change to the
antenna or the device is permitted.
Any change to the antenna or the
device could result in the device
exceeding the RF exposure
requirements and void user’s authority
to operate this device.
Notice for customers in Canada:
Use of Sony wireless devices is
regulated by the Industry Canada as
described in their Radio Standard
Specification RSS-123.
A licence is normally required. The
local district office of Industry Canada
should therefore be contacted. When
the operation of the device is within
the broadcast band, the licence is
issued on no-interference, no-
protection basis with respect to
broadcast signals.
Operation of this device is subject to
the following two conditions: (1) this
device may not cause interference, and
(2) this device must accept any
interference, including interference
that may cause undesired operation of
the device.
The term “IC:” before the radio
certification number only signifies that
Industry Canada technical
specifications were met.
Remarque à l’intention des
utilisateurs au Canada:
L’usage des appareils sans fil Sony est
réglementé par l’Industrie Canada
comme décrit dans leur Cahier des
Normes Radioélectriques CNR-123.
Une licence est normalement requise.
Le bureau de l’Industrie Canada doit
être contacté. Lorsque le
fonctionnement de l’appareil respecte
les limites de la bande de
radiodiffusion, la licence est accordée
sur la base d’une non-interférence,
non-protection pour les signaux de
radiodiffusion.
L’utilisation de cet appareil est
soumise aux deux conditions
suivantes: (1) cet appareil ne peut
causer d’interférences, et (2) cet