Filter
Top Products
T.52 CONTROL OVERVIEW
1. Start/Stop - Press this button to start or stop the platter.
2. Strobe dots - The dots around the edge of the platter are used in conjunction
with the light located inside the motor ON/OFF switch. While the platter is in
rotation, the dots help to indicate the speed of rotation. The speed is lower than
the displayed speed (33,45,) when the dots are flowing to the right. It is higher
than the displayed speed (33,45,) when the dots are flowing to the left. When
the strobe is stopped, the platter is rotating at the displayed speed.
3. Slipmat
4. Center spindle
5. Power on/off
- On - Rotate right
- Off - Rotate left
6. Platter revolution speeds
- 33 rpm Press 33
- 45 rpm Press 45
7. Target light - Insert target light to the deck and it will light up.
8. Pitch slider - Use this to change the speed of the platter when the PITCH
indicator is lit.
9. Headshell locking nut - Attach headshell by inserting into the front end of
the tone arm, then turn the locking nut clockwise with the head shell firmly held
horizontally.
10. Tonearm
11. Tonearm clamp and rest - Use this rest for the tone arm and clamp it in
position during transportation.
12. Counterweight - Use this to balance the tonearm and to adjust the stylus
pressure.
13. 45 rpm adapter holder - Place the attached 45 rpm adapter here.
14. Output L&R - This is the standard analog output (RCA jacks) which should
be connected to a phono input on any DJ mixer.
15. GND - Ground.
16. Power cord connector - Used to connect the supplied power cord.
8
T.52