Filter
Top Products
ROTATING THE TRANSFORM SWITCHES
The input selector (transform) switches on the Stanton SA.3
mixer can be rotated to 8 different positions. Follow the steps
below to rotate the transform switch to the position you like.
1. Make sure the mixer is powered off. Remove the faceplate of
the mixer.
2. Remove the two outer screws
from the transform switch as indi-
cated in diagram. Do not remove
the two inner screws.
Removing
the two inner screws will detach
the switch from the plate.
3. Rotate the switch to the posi-
tion you like. Replace the two
outer screws to secure the switch
in place.
Replacing the transform switch
1. Follow steps 1 and 2 above.
Remove switch from mixer and
detach connector from switch.
2. Attach connector for transform
switch to replacement switch and replace two outer screws to
secure the switch in place.
REPLACING THE CROSSFADER
The SA.3 is compatible with the CFSA.3, Focus Faders V1/V2
and with Penny and Giles crossfaders. The SA.3 has two differ-
ent circuits which need to be switched when changing between
the faders. To switch the crossfader circuit, follow the instruc-
tions below:
1. Follow steps 1 & 2 from the fader cleaning instructions.
2. Remove the fader assembly and discon-
nect the cable coming from the mixer.
3. The crossfader select switch is located
inside the mixer, on the left side of the
fader slot. In order to use the CFSA.3, FF1
and Penny & Giles faders, make sure the
switch is pressed DOWN. To use the CFF2,
make sure the switch is in the UP position.