Filter
Top Products
REMOVING FACEPLATE
CLEANING FADERS
2
2 2
2
3 3
3
1. Unplug the power
supply from the back
of the mixer. Verify
that the mixer is pow-
ered off.
2. Remove the 4
screws on the face-
plate. Place the 4
screws somewhere
safe where they will
not be lost.
3. Remove the 3 fader
knobs from the line
faders and crossfader.
4. The faceplate can
now be removed from
the top of the mixer.
1. Make sure the mixer
is powered off. Remove
the faceplate of the
mixer by following the
directions above.
2. Remove the fader from the mixer
by unscrewing the two outer screws
on the fader plate. Do not remove
the two inside screws on the fader
plate; this will remove the fader
from the fader plate.
3. Once fader has been removed
from mixer, spray a small amount of
contact cleaner into the fader and
move the fader back and forth to
disperse the cleaner.
(BACKPANEL VIEW)