Filter
Top Products
PAGE 32 — STOW MS-70 MIXER — OPERATION MANUAL — REV. #3 (03/26/10)
STOW MS-70 PLASTER/MORTAR MIXER — MAINTENANCE (MIXER)
Figure 35. Axle Support Components
Suspension
Mixer Cleaning
1.
ALWAYS
disconnect the spark plug wire
(gasoline
engines) before cleaning the inside of the drum. If mixer is
equipped with an electric motor
remove power cord from
AC power receptacle
. In addition make sure the clutch
engagement lever is
dis-engaged
.
2. Make sure the rear section of the safety grate is connected
to the mixing drum.
3. At the end of each day’s operation, place mixer drum in an
upright position and spray inside of tub immediately with
water to prevent lumps of dried mortar or plaster from
forming and contamination of future batches, DO NOT allow
a buildup of materials to form on the blades or anywhere
inside the drum.
4. Rotate mixer to dump position and remove debris.
5.
Thoroughly clean
the entire mixer, wheels, cabinet and
frame.
6.
NEVER!
pour or spray water over the engine or electric
motor (Figure 36).
Mixer Storage
.
7. When cleaning of the entire mixer is done, return mixing
drum to an upright position.
Figure 37. Safety Grate (Crush Hazard)
Figure 36. No Spraying of Water
When rotating the mixing drum from the dump position to the
upright position, keep hands clear of safety grate. The
possibility exists of hands or fingers being crushed (Figure 37).
WARNINGWARNING
WARNINGWARNING
WARNING
Keep Hands
Clear of Drum!