Filter
Top Products
SX-ST / SX-SV User Manual page 28
8. SPECIFICATIONS
General and notes
All specifications mentioned hereafter apply to standard models only.
SONOSAX SAS SA reserves the right to modify these characteristics at any time without prior notice.
For measures and/or settings the reference is: 0dBu = 0.775V (i.e. + 6dBu = 1.55V).
Summary of characteristics
Frequency response : 10Hz to 200kHz ± 0.5dB
20Hz to 200kHz ± 0.1dB
Equivalent input noise : -128dBu ( 20Hz to 200kHz - 150 Ω source @ 60dB gain )
Input gain Fixed Steps : 60dB 48dB 36dB 24dB 12dB 0dB
Input gain Fine : ± 20dB from CAL Position ( 40dB end to end )
Fader gain : selectable +12dB or +24dB
Global gain range: fader @ 0dB - 20dB to +80dB
fader @ +12dB - 8dB to +92dB
fader @ +24dB +4dB to +104dB
Overall dynamic range : 128dB
Input headroom : 24 dB
Crosstalk between 2 channels : better than 100dB 10Hz to 1kHz
better than 90dB 10Hz to 20kHz
Overall THD+N :
Main Level meters: moving coil Peak Meters IEC-268-10 type 1 ( factory default )
internally selectable to IEC-268-10 type 2 or absolute Peak
large level scale from -32dB to +12dB
reading 0dB at nominal level
switchable to Level and Phase Correlation meter
battery level indication
LED's Level indicators : red +6dB
yellow 0dB nominal level
green - 10dB
green - 20dB
green - 40dB
overload indication: turns all leds ON 6dB before clipping
Led level reading accuracy: ± 0.1dB
Nominal output level : +6dBu or +4dBu
0dB reading on all Peak level meters reflect the nominal level
An internal jumper sets the global nominal level of the entire mixer.
It automatically affects the setting of all peak-meters, output levels,
the internal 1kHz ref tone, the 0 setting of the limiters.