Filter
Top Products
IMPORTANT SAFETY INSTRUCTIONS
TASCAM CD-RW900SL 19
4 − Playback operations
TASCAM CD-RW900SL 19
Time display switching
When the TIME key on the front panel or the remote
control is pressed, the time display will switch through
several modes on the display.
Elapsed track time (no display light indication)
Remaining track time (REMAIN is lit in the display)
Elapsed disc time (TOTAL is lit in the display)
Remaining disc time (TOTAL and REMAIN are lit in the
display)
When stopped, the total recording time is shown, regard-
less of the status of the TOTAL and REMAIN indicators.
•
•
•
•
NOTE
In program mode, pressing the TIME key displays the
elapsed and the remaining time of the whole program.
When playing an MP3 disc, elapsed track time is
always displayed, and the TIME key cannot be used.
For details on time display during recording, please
refer to “Time display while recording” on page 24.
Even when power is turned off, the time display mode
setting is retained.
Timer playback
By using an external timer, you can set the CD-RW900SL
to play the loaded disc automatically when the unit is
turned on by the timer.
1. First, plug the power cord of the CD-RW900SL into
the power outlet of the timer.
2. Load a disc into the unit.
3. Switch the TIMER switch on PLAY to enable timer
function on for the desired deck.
When Timer playback has been turned on, the
timer icon lights up in the display.
NOTE
The indicator flashes when a disc is not loaded into
the unit.
4. Set the timer to the desired time. Consult the timer’
s operation manual for details. At the set time, the
power to the CD-RW900SL will be turned on, and
playback will automatically begin.
Timer indicator
When stopped, if the playback mode is switched to
another, all the program data will be erased.
The programmed play order is not memorized when
power is turned off.
In this mode, if there are no tracks programed, the
CD-RW900SL will not start playback.
If an attempt is made to enter more than 100 program
steps, the message PGM Full! appears on the display.
If the total program playing time exceeds 999 min 59
sec, --- : -- appears on the display.
Repeat playback
1. Press the REPEAT key to turn on the repeat mode.
In this mode, all the tracks on the disc are played
continuously. The display shows Repeat ON and the
indicator lights up REPEAT.
During playback, if the repeat mode is turned on,
playback continues as before, and when the last track
finishes, playback resumes from the first track.
If the repeat mode is turned on when the deck is
stopped, press the PLAY key to begin operation.
2. Press the REPEAT key again to turn off repeat
mode. Repeat OFF appears then the REPEAT indicator
turns off.
NOTE
Combining the repeat mode with the program,
Single-track playback and Random playback functions
will enable Program repeat, Single-track repeat and
Random repeat operations, respectively.
Settings for the repeat playback mode remain after
power is turned off, except the specified A-B section
(see “A to B repeat playback” on page 20).